Water Tight Rain Water / Drain Outlet - 100mm EPDM Roofing Membrane Flat Roofs
This 100mm Rain Water Outlet is a flat roof synthetic rubber drain outlet for downpipes. To be used with EPDM Rubber Roofing installations, the wide base with ribbed surface provides ample anchorage for the membrane.
Description
This Rain Water / Drain Outlet – 100mm is a flat roof synthetic rubber drain outlet for downpipes. To be used with EPDM Rubber Roofing installations, the wide base with ribbed surface provides ample anchorage for the membrane. The flanges on the cylinder form a seal with the inner surface of the pipe.
How to use:
-
Once rubber has been laid, Cut hole for drain to go through.
Apply water cut off mastic to under side of flange, Then fix down using fixing plates.
Apply Primer to drain unit and surrounding EPDM (Min 2” / 50mm cover) using scrubpad
Lay appropriate sized flashing tape over complete drainage unit and onto EPDM ( Recommended 0.5m of 18” flashing tape over primed area.)
Cut hole in flashing tape to allow water to drain off roof.
If you have any queries, please get in touch with our friendly team. Call us if you are unsure about the materials you need for your roof on 01392927729 or email sales@rubberflatroof.co.uk. You can also check out our Roof Calculator that estimates all the materials you will need for your rubber roofing project.
